These are the exact 20 questions served in the free sample of the Water Treatment Class II Exam Prep program, in serve order, with the correct answer and a full explanation for each. The sample mixes easy, medium, hard, and stretch questions (5 / 7 / 5 / 3) drawn from this program’s own content areas.
The 20 free sample questions
1. A plant treats 2.0 MGD at a coagulant dose of 30 mg/L. How many pounds per day are fed?
A. 500.4 lb/day
B. 60.0 lb/day
C. 5,004 lb/day
D. 166.8 lb/day
Correct: A. Pounds = flow x dose x 8.34 = 2.0 MGD x 30 mg/L x 8.34 = 500.4 lb/day. Omitting 8.34 gives the 60.0 lb/day distractor.
2. A plant ozonates bromide-bearing source water. Why must the ozone dose be constrained?
A. Ozone can form bromate, a disinfection byproduct
B. Ozone leaves a very long-lasting residual behind
C. Bromide makes ozone generation impossible to run
D. Ozone will deposit calcium carbonate in the mains
Correct: A. In bromide-bearing water, ozone can form bromate, a disinfection byproduct, which constrains the ozone dose that can be applied.
3. Why are reorder points established for treatment chemicals and critical spare parts?
A. To allow storage areas to be emptied completely before new stock arrives
B. To trigger reordering in time so critical items do not run out of stock
C. To limit inventory paperwork by ordering only after a stockout has occurred
D. To keep the largest possible inventory on hand regardless of shelf life
Correct: B. Inventories are tracked with reorder points so critical spares and treatment chemicals never stock out. Ordering only after a stockout can interrupt treatment.
4. Surging, as a well rehabilitation method, works by:
A. Pumping the well continuously at maximum rate until the aquifer is completely drained
B. Moving water back and forth through the screen to loosen deposits
C. Sealing the screen openings so no sand can ever enter the well
D. Heating the well water to kill bacteria living on the screen
Correct: B. Surging reverses flow through the screen repeatedly, breaking loose encrustation and biofouling material so it can be bailed or pumped out. It loosens deposits rather than sealing or draining the well.
5. What is the purpose of the intensity sensor on a UV disinfection reactor?
A. It tracks actual lamp output so dose can be verified as lamps age and sleeves foul
B. It measures the turbidity of the water entering and leaving the reactor continuously
C. It counts the hours each lamp has been in service
D. It adjusts the chemical disinfectant feed downstream
Correct: A. Lamp output falls as lamps age and sleeves foul. Intensity monitoring shows the dose actually being delivered so cleaning or lamp replacement happens before disinfection suffers.
6. In the alkalinity titration, the sample is titrated with what reagent to the method endpoints?
A. A standard acid, with results reported as mg/L as CaCO3
B. A standard chlorine solution made in the DPD reagent
C. An EDTA solution that has been buffered to hold pH near 10
D. A sodium thiosulfate solution from a sterile bottle
Correct: A. Alkalinity is measured by titrating the sample with standard acid to the phenolphthalein and total alkalinity endpoints, and results are reported as mg/L as CaCO3.
7. Monitoring suggests a possible contamination event in finished water. What is the supervisor’s best course of action?
A. Wait a full day to see whether later results confirm the first finding
B. Keep the finding within the shift until a cause is proven with certainty
C. Follow the emergency plan, verify the data, and escalate for notification
D. Increase chemical feed and take no other action unless complaints arrive
Correct: C. Contamination events are handled under the emergency response plan, with data verified and the situation escalated so public notification decisions are made promptly. Delay risks public health.
8. A VFD-driven pump trips on DC bus overvoltage whenever it stops. Extending the deceleration ramp clears the fault. Why?
A. The check valve was slamming and sending pressure spikes into the drive cabinet during routine plant operation
B. The drive’s cooling fan only runs during long ramps, so the bus stays cooler
C. A longer ramp lets the drive absorb the motor’s regenerated energy gradually instead of spiking the DC bus
D. Extending the ramp raises line voltage enough to reset the fault relay
Correct: C. A spinning pump and motor act as a generator while slowing down. If deceleration is too fast, that energy charges the DC bus faster than the drive can dissipate it, causing an overvoltage trip; a longer ramp spreads the energy out.
9. As potassium permanganate reacts with dissolved iron and manganese in the water being treated, what happens to its pink-purple color?
A. It disappears as the permanganate is consumed oxidizing the iron and manganese
B. It turns blue to show the hardness endpoint has been reached
C. It deepens steadily no matter how much iron is present
D. It changes to green only when chlorine is also present
Correct: A. Permanganate’s pink-purple color disappears as it is consumed oxidizing dissolved iron and manganese. Persistent pink color signals overfeed, which can turn finished water pink.
10. Water flows through a channel with a cross-sectional area of 10 sq ft at a velocity of 2 ft/sec. What is the flow in gpm?
A. 20.0 gpm
B. 4,488 gpm
C. 17,952 gpm
D. 8,976 gpm
Correct: D. Q = A x V = 10 x 2 = 20 cfs. Convert: 20 x 448.8 = 8,976 gpm. The 20 gpm choice skips the cfs-to-gpm conversion.
11. Differential level across an intake trash rack keeps rising and raw-water flow is falling. What should the operator do first?
A. Inspect and rake the trash rack to clear debris
B. Increase raw-water pump speed to pull harder through the rack
C. Close the intake gate and leave the rack fouled overnight
D. Raise coagulant feed ahead of the intake to dissolve debris
Correct: A. A rising differential across the rack signals accumulated debris restricting flow. Clearing the rack restores intake capacity; forcing the pump harder risks cavitation and damage.
12. Winter source water is much colder than summer water. To hold the same pathogen inactivation, the operator should expect to need:
A. Less CT because cold water holds chlorine longer
B. No change, since temperature does not affect CT
C. More CT, because colder water requires more CT
D. A lower residual with a much shorter contact time
Correct: C. Colder water requires more CT for the same inactivation, so residual or contact time must increase in winter conditions.
13. A high-service pump’s vibration has risen steadily over three monthly readings — 0.12, 0.19, then 0.28 in/s — but is still below the 0.40 alarm level. What is the best action?
A. Plan a diagnostic check and likely repair at the next opportunity, because the trend shows a developing fault despite the sub-alarm value
B. Wait for the alarm, since acting below it wastes maintenance resources
C. Delete the trend and restart the baseline at the newest reading
D. Slow the pump permanently to half speed to silence the readings
Correct: A. Trend rate matters as much as absolute level. A near-doubling pattern signals an actively developing fault; planning the diagnosis and repair now is far cheaper than a forced outage when it crosses the alarm.
14. While titrating an alkalinity sample, the analyst adds too much titrant and blows past the endpoint color change. What is the correct action?
A. Estimate where the endpoint probably was and record that volume as the titration result on the bench sheet
B. Discard that aliquot and retitrate a fresh portion, approaching the endpoint drop by drop near the end
C. Add base until the color returns, then keep titrating
D. Report the overshot volume, since extra acid adds safety
Correct: B. An overshot endpoint cannot be backed out reliably. The aliquot is discarded and a fresh portion is titrated, slowing to drop-by-drop addition as the endpoint nears.
15. A plant treating 0.8 MGD needs a pure chemical dose of 35 mg/L. The available product is 50% pure. How many pounds of product per day are required?
A. 233.5 lb/day, the pure chemical need with no purity correction made
B. 116.8 lb/day, the pure need multiplied by the purity instead of divided
C. 46.7 lb/day, the pure need divided by a purity entered as a whole number
D. 467.0 lb/day, the pure chemical need divided by the purity as a decimal
Correct: D. Pure need = 0.8 x 35 x 8.34 = 233.5 lb/day. Product = 233.5 / 0.50 = 467.0 lb/day.
16. A training-record audit shows one operator’s confined-space refresher has lapsed, though he entered a space last week. What should the supervisor do?
A. Remove him from entry duties until retrained, document the gap, and review how it was missed
B. Backdate the training record to the week before the entry so the file appears complete
C. Let him keep making entries because his years of experience substitute for the refresher this week
D. Wait for the next scheduled plantwide training day, several months away, to correct it
Correct: A. Lapsed required training means the operator comes off that duty until retrained. The gap is documented honestly and the tracking process is reviewed; records are never backdated.
17. An infrared survey finds one breaker lug running 70°F hotter than its neighbors under similar load. What is the correct response?
A. Spray the lug with contact cleaner while it stays energized and loaded under typical plant conditions in most plants
B. Note it and rescan in a year, since breakers normally run hot
C. Move the load to the hottest phase to balance the temperatures
D. Schedule a de-energized repair to clean, inspect, and properly torque or replace the connection before it fails
Correct: D. A large temperature difference at a connection means high resistance and active heating that will worsen. The safe fix is planned, de-energized work: open it up, clean or replace damaged parts, and torque to specification.
18. At the same pumping rate as last year, a well’s pumping level is now much lower while its static level is unchanged. What does this suggest?
A. The aquifer has gained water, because a lower pumping level means more storage
B. Conditions at the well, such as the screen, have worsened
C. The pump is oversized and should be replaced with a much larger unit immediately
D. Static level no longer matters, so level monitoring of the well can be stopped
Correct: B. If static level is stable but the pumping level drops at the same rate, resistance at the well itself — often screen encrustation — has increased.
19. An inspection finds a crack in a well casing just below ground level, with stained soil beside it. The operator should treat this finding as:
A. A cosmetic defect that can safely wait for the next scheduled painting
B. Proof the aquifer itself has become contaminated deep underground
C. A reason to increase the pumping rate to flush out the crack
D. A direct pathway for surface contamination into the well
Correct: D. Together with the sanitary seal, the casing is the barrier keeping surface water out of the well. A crack breaks that barrier and lets surface contamination enter directly, so repair is a priority finding.
20. A chloraminated system finds swimming-pool odors and falling total chlorine at a storage tank, and free ammonia there has risen. What is the most likely cause?
A. The chlorine-to-ammonia ratio has drifted, favoring dichloramine formation and decay
B. The tank water has grown too cold over the winter for chloramine to persist in storage
C. The free chlorine residual in the tank is too high
D. The tank was cycled too often during the past week
Correct: A. Monochloramine is the desired species. When the chlorine-to-ammonia ratio drifts and free ammonia rises, dichloramine forms, causing the pool-like odor, and the combined residual decays faster.
Take the sample as a timed quiz in the full program: open the free sample quiz. The full program carries 500 questions with an explanation for every answer — enroll for $49 with 6 months of access. See also the Water Treatment Class II exam guide.
Disclaimer
PassProfessor is an independent exam-preparation provider. This program is exam preparation only: it is not the real exam, it provides no education credit, and completing it does not by itself qualify you for any license or certification. The real exam is run by its own exam body — you register for it, pay its fees, and sit it through that body, not through PassProfessor. All practice questions in this program are original; they are not actual exam questions.
